We can provide the wire rod block mill layout. And designing, manufacturing, installation and commissioning of the equipment with "turn-key" service.

Top cross 45° high-speed wire rod finishing mill designed for the high-speed wire rod production line. Rolling Φ5.5~Φ16 mm finished wire rod. Rolling speed is 90 m/s.

Laying head is a very important part of wire rod mill. Type: Horizontal laying head wire rod diameter: Φ5.5~14mm, Coil diameter: Φ1040mmMaximum spinning speed: 90m/s.

The roughing mill stands are used to reduce the thickness of the steel while at the same time extending the overall length. Rolling mill stand is an important part of a work stand, roll bearing chock and roller adjustment device is installed on the frame.

Rolling mill cold shear is an important part in rolling mills, Function: cutting head and cutting tail, accident broke, etc. Model: starting-stop flying shears. Shearing model: crank type cold shear

Pre-finishing mill type: cantilever mill, rack number: 4 stands; Horizontal mill (2 stands), Vertical Looper (3 sets), vertical mill (2 stands), safety cover; Layout and transmission mode: horizontal - vertical - horizontal; H-V-H-V, direct current (DC) motor individual drives.

Pinch Roll is the horizontal cantilever structure. It has a double roll device and one air cylinder which is used to control roll up and down synchronous clamp. Pinch roll DC motor is used to improve drive speed by two-stage cylindrical gear.

The flying shear of rolling mill is after conveying guide groove for cutting head of rolled piece and emergency accident. Flying shear need to cut the head and rear to ensure the quality of the rolling parts before it gets into the finishing mill.

Side loop of rolling mill is before finishing mill group, function is achieving Tension-free rolling between pre-finishing mill and finishing train. Side loop one set.